Coleman 011-2044-8, Руководство пользователя

Страница: 9 / 40

Connect the Wind Generator to the wires and insulate the connections using either heat
shrink tubing crimp connects or a high quality electrical tape.
The included rubber gasket helps prevent the bottom of the yaw from contacting the
top of
the pole. This rubber gasket will assist in reducing the transmission of noise down the tower.
Firmly tighten the yaw clamp screws with the 4mm hex key. Be sure that it is securely
attached to the mounts.
Slide the yaw shaft all the way down over the end of the tower being careful not to pinch
the yaw wires. Be sure to leave enough slack in the wires so that if necessary, the Wind
Generator can be removed.
Mark both ends of all the wires with tape to identify which is negative, positive and ground
Wire Color Codes:
RED = Positive
BLACK = Negative