Coleman 011-2044-8, Руководство пользователя

Страница: 7 / 40

S I T I N G
Prior to the mounting of your Coleman Wind Turbine, you must carefully consider a
location.
Things to consider when thinking about your location
1. Distance from any obstacles that will cause turbulence, trees, buildings etc.
2. Distance between turbine and battery bank
3. Any local zoning restrictions
4. Clearance of power lines
In general terms, the higher the tower the less obstruction to air flow there is, leading to a
more efficient chare capacity. The minimum recommended tower height is 30 ft or 20 ft
above nearby obstructions as shown below.
TOW E R
Your Coleman Wind Turbine is designed to make mounting as simple and straightforward
as possible. Should you not wish to purchase the custom Coleman tower kit feel free to
utilize schedule 40 1.5 inch steel tubing. This should be available through your local
hardware outlet. Contact your local Sunforce Products dealer for information on tower kits
for this turbine!
I N S T A L L A T I O N
R E Q U I R E D T O O L S
Stop Switch (included)
Plastic Disks (included)
4mm hex key wrench (included)
5mm hex key wrench (included)
8mm hex key wrench (included)
Power cables (not included):
Batteries (not included)
Steel Pipe: 1 1/2“, Schedule 40 steel pipe (Actual OD 1.875 inches, 48mm) (not included)
Torque wrench
Electrical tape or 1/4” (6-7mm) heat shrink (not included)
Wire strippers (not included) Wire crimpers (not included)