Cole Parmer EW-36620-40, Инструкция по эксплуатации

Страница: 8 / 16

❖ Replace the sealing pad with the new one. Reassembly is the reverse of the above procedure.
In Case of Contamination
WARNING: THE FOLLOWING PROCEDURE IS INTENDED AS A GUIDE. SHOULD SPILLAGE OF A
TOXIC OR HAZARDOUS FLUID OCCUR, THEN ADDITIONAL SPECIAL PRECAUTIONS MAY
BE NECESSARY.
If the equipment has been exposed to contamination, the Responsible Body is responsible for carrying out
appropriate decontamination. If hazardous material has been spilt on or inside the equipment, decontamination
should only be undertaken under the control of the Responsible Body with due recognition of possible hazards.
Before using any cleaning or decontamination method, the Responsible Body should check with the
manufacturer that the proposed method will not damage the equipment. Prior to further use, the Responsible
Body shall check the electrical safety of the unit. Only if all safety requirements are met can the unit be used
again.
NOTE: In the event of this equipment or any part of the unit becoming damaged or requiring service, the item(s)
should be returned to the manufacturer for repair accompanied by a decontamination certificate. Copies of the
Certificate are available from the Distributor/Manufacturer.
At the end of its service life, the product must be accompanied by a Decontamination Certificate.
Servicing and Repair
This product range does not require any routine servicing, instructions for cleaning and decontamination are
included.
In the event of product failure, it is recommended that any repair is only undertaken by suitably qualified
personnel. For advice, please contact Cole-Parmer quoting the model and serial number.
Only spare parts supplied by the manufacturer or its agent should be used. Fitting of non-approved parts may
affect the performance of the safety features of the instrument.
If in doubt, please contact:
Antylia Scientific Ltd Ltd.
Beacon Road,
Stone, Staffordshire,
ST15 0SA, United Kingdom
Tel: +44 (0)1785 812121
Email: cpservice@antylia.com
Web: www.coleparmer.com
Warranty
Antylia Scientific Ltd Ltd. warrants this equipment to be free from defects in material and workmanship when
used under normal laboratory conditions for the period specified on the enclosed warranty card. In the event of
a justified claim, Antylia Scientific Ltd will replace any defective component or replace the unit free of charge.
This warranty does NOT apply if:
❖
Any repair has been made or attempted other than by the manufacturer or its agent.
❖
Any minor coating chips or scratches occur during normal use (i.e., wear and tear).
❖
Damage is caused by fire, accident, misuse, neglect, incorrect adjustment or repair, damage
8