WARNING: Before installing tubing into the Pump Head remove
power or shut off the drive. Fingers or loose clothing could be
caught in the rollers.
1. Place the Power On/Direction Switch, Figure 1-2, in the center (Off)
position.
2. Open the Door, Figure 1-2, by grasping the finger recesses on either
side and pulling away from the pump.
3. Occlusion Bed releases automatically when Door is opened, Figure 2.1.
Figure 2-1.
Door Open - Occlusion Bed has No Tubing Contact
4. After cutting the desired length of tubing, place the tube onto the rotor
allowing the tube to naturally curve around the rotor. Insert one side of
the tubing into tube retainer by moving the retainer toward the center of
the pump and placing tubing in the v-notch of the retainer. Release the
retainer so that the tubing is secured in place. Repeat for the other Tubing
Retainer. The tubing should be stretched slightly around the rollers so that
there is no excess tubing between the Rollers and Retainers, Figure 2-1.
Tubing
Retainers
Rollers
Occlusion
Bed
2-2
FH10 MICROFLEX
®
Pump System Operating Manual
Cole-Parmer
Section 2
Installation and Setup
Installing Tubing
in Pump Head
Occlusion Bed
sets in place
automatically
as Door
closes
