Coldelite EPS 60 XP, Инструкция по эксплуатации, Страница: 14 / 29

- 14 -
EPS XP
eps xp_EN - 09/10 - ed. 2
2.4 MACHINES WITH WATERCOOLED CONDENSER
To make the machine run, a watercooled machine must be connected to running water
supply, or to a cooling tower.
Water must have a pressure of 0.1 MPa and 0.8 MPa (1-8 bar) at least, and a delivery at
least equal to the estimated hourly consumption.
Connect inlet pipe marked by plate "Water Inlet" to water supply installing a shut-off valve,
and outlet pipe marked by plate "Water Outlet" to a drain pipe, installing a shut-off valve.
2.4.1 Water valve adjustment
IMPORTANT
If water valve needs be reset, this operation will have to be carried out by skilled personnel,
only.
Valve adjustment must be carried out in such a way that no water flows when machine is off
and lukewarm water flows when machine is on.
NOTE
Water consumption increases if temperature of entering water is above 20°C.
ATTENTION:
Do not leave the machine in a room with temperature below 0°C
without first draining water from the condenser.
2.5 ELECTRIC CONNECTION
Before connecting the machine to the mains, check that machine voltage indicated in data
plate corresponds with the mains.
Insert a differential magnetothermal protection switch adequately sized to absorption capacity
required and with contact opening of 3 mm at least.
The machines are delivered with a 5 wire cable: blue wire must be connected to the neutral
lead.
IMPORTANT
Yellow/green ground wire must be connected to an adeguate ground plate.
2.5.1 Replacing the power cable
Should the machine main cable be damaged, it must be replaced immediately with one having
similar features. Replacement shall be carried out by skilled technicians, only.
IMPORTANT
Direction of rotation
Eps xp beater direction is clockwise in beating mode and full charge, whilst it is
anticlockwise in half charge mode.