COINWASH TD30X30, Руководство по обслуживанию

Страница: 95 / 106

1
487 0329 81
3
42. Drum with bearing 42
Service
manual
Dismounting of drum / drum belt
1. Disconnect the power supply to the dryer.
2. Remove the rear panels.
3. Loosen the belt, see
Loosening the belt tensioner of the drum motor
section 30.
4. Remove the top door hinge.
5. Lift the door off the bottom hinge; remove the bottom hinge.
6. Remove the front panel fastening screws and remove the panel.
7 . Unplug the wire to the door switch.
8. Loosen the fastening nut in the top of the door switch panel and remove the panel with
door switch mounted.
9. Unscrew the 3 screws of the bearing cover and remove the cover.
10. Fig.1 Unscrew and remove bolt and washer from the main drum bearing.
11. Pull out the drum.
The drum, internal sealings or the belt can now be replaced.
Replacement of internal sealings
1. Inspect both sealings
A + B
and replace if defective.
2. Remove the defected sealing
A
or
B
, clean any residual adhesive before installing a
new sealing.
3. Replace the sealing
A
or
B.
4. If replacing sealing
A
remove the fastening screws in the sealing joint.
The same screws are used to fasten the new sealing.
Note! If seal
A
has been replaced it is necessary to put a thin coating of silicone oil on
the drum in a distance of 40mm from the perforation for air out. In the position where the
sealing
A
is running.
2
A
B