Cognex In-Sight VC200, Справочное руководство

Страница: 20 / 57

Install the Camera
The following sections provide steps for installing the camera and connecting it to the vision controller.
Mount the Camera
The camera provides mounting holes for attachment to a mounting surface.
Note :
l
For the mounting holes closest to the lens opening, the thread length of the M3 screw should not exceed
4.5mm. For the mounting holes closest to the connectors, the thread length of the M3 screw should not
exceed 1.6mm. This does not include the thickness of the mounting material used. For more information,
refer to ISC-8402 Dimensions on page 46 and ISC-8405 Dimensions on page 48 .
l
The accessory mounting kit includes a mounting block and M3 screws (quantity 4) for mounting the camera
and securing it to a mounting surface. The mounting block also provides 1/4-20 and M6 mounting holes for
attaching the camera to a mounting surface. For more information, refer to ISC-8402 Dimensions (with
Accessory Mounting Block) on page 47 and ISC-8405 Dimensions (with Accessory Mounting Block) on
page 49 .
l
It is recommended that the camera be grounded, either by mounting the camera to a fixture that is
electrically grounded or by attaching a wire from the camera's mounting fixture to frame ground or Earth
ground.
1. Align the holes on the mounting surface with the mounting holes on the camera.
2. Insert the M3 screws into the mounting holes and tighten using a 2.5mm hex wrench; the maximum torque is
0.3 Nm (2.5 in-lb).
20
Installation