English
mounting
ProSpot LX
can operate in any mounting position.
The structure from which the unit is hung should be of sufficient
rating to hold the weight of the unit, as should any clamps used to
hang the unit. The structure should also be sufficiently rigid so as to
not move or shake whilst the
ProSpot LX
moves during its opera-
tion.
The two mounting holes Ø13 mm (
A
) on the base of the
ProSpot
LX
allows the projector to have hook clamps fitted for the purpose
of hanging.
safety chains
The use of a safety chain fixed to the
ProSpot LX
and to the pri-
mary suspension structure is highly recommended to protect against
the accidental failure, however unlikely, of the primary suspension
point.
If using an aftermarket safety chain not manufactured by
coemar
,
ensure that it is of a sufficient rating to hold the weight of the unit.
The safety chain is attached by means of the two holes
B
located in
the base of the unit as shown in the diagram.
movement
The projector has an articulated movement of 530° in the base and 284° through its yoke;
DO NOT
obstruct the articula-
ted movement in any way.
protection against liquids
The projector contains electric and electronic components that must not come into contact with water, oil, or any liquid.
risk of fire
Each fixture produces heat and must be installed in a well-ventilated position. The minimum recommended distance from
flammable material is 0.5m. Minimum distance from the object being illuminated is 2m.
forced ventilation
You will note that the projector’s housing contains several air entry points and fan outlets, positioned both on the head and
the base of the unit; under no circumstances should any of these points be obstructed!
Obstruction of any of these points will result in the over-heating of the unit, detrimentally and seriously affecting the proper
operation of the
ProSpot LX
.
On this point, refer to section
18 “Electronic motor alignment”
, subsection temperature (
temp
).
6. Installing the unit