Coemar LEDko EXT FullSpectrum RGBLA, Руководство пользователя

Страница: 15 / 33

15
A00 1
7
. Turning the projector on
After having followed the preceding steps described, proceed with the power supply and turn on the projector
connecting it to the mains power.
The software version installed on the internal microprocessors will be shown on the display, suddenly it will show
the current DMX addressing. If the address blinks, it means that the DMX signal has not been received. Check
the connection cable and the mixer functioning.
7.1
DMX address of the unit
Each projector can use 16, 7, 1 address ch Studio and RGB mode for its complete operation and is
controlled by a DMX 512 signal.
DMX addressing
When powered up initially, each projector will show A001, which indicates DMX address 001; for example,
when set at 16 channels a projector thus addressed will respond to commands of channel 1 to 16 from your DMX
512 controller. A second unit must be addressed as A017, a third one as A033 and so on. The operation must be
carried out on every
LEDko EXT FullSpectrum RGBLA
which has an address different from A001.
Altering the DMX address:
1.
Press the + or – button until the display shows the required DMX address. The digits on the display will blink
to indicate that the variation has not been registered.
2.
Press the enter key to confirm your selection. The digits on the display panel will cease to blink and the
projector will now respond to the new address.
Note:
by holding the + or – button down the scrolling will be faster; thus allowing a faster selection
Warning!
If you alter the DMX address with no DMX signal connected, the digits on the display
panel will continue to flash even after you have pressed ENTER button to confirm the
address.