Coemar Infinity Wash M, Инструкция по эксплуатации

Страница: 10 / 29

English
10
Identify the mains cable which exits the base of the unit and connect as shown below.
WARNING !
• The use of a thermal magnetic circuit breaker is recommended for each projector. Strictly adhere to all regulatory norms.
• Infinity Wash M cannot be powered through Dimmer power units.
• A good earth connection is necessary for the correct operation of the Infinity Wash M. Never connect the projector to main power if
the green/yellow earth cable provided is not correctly connected.
• All cable and plug connections must be carried out by qualified personnel only.
6. Control signal connections
The digital control signal is transmitted to the projector via a two pole cable screened as per international standards for the transmission of DMX512
data. The connection must be serial, utilising connectors XLR3 and XLR5, male and female, located on the base of Infinity Wash M labelled DMX
512 IN and OUT (see diagram)
Control signal connection by XLR3 e XLR5 plugs
Pin 1= GROUND
Pin 2= DATA -
Pin 3= DATA +
Pin 4= NC
Pin 5= NC
When signal arrives from a DMX 512 console with Cannon XLR5 ( 5 poles) pins 4 and 5 must not be connected.
WARNING !
Make sure that screening and conductors are not in contact one another or with the metal housing of the connector.
Pin n# 1 and housing must never be connected to the unit power supply.
6.1 Connection through ArtNet.protocol
The ArtNet protocol allows enabled projectors to operate and to be seen as a normal network device, such as a standard P.C. connected to a
company network.
Infinity Wash M leaves the factory ready to be connected to an ArtNet network without any further settings. Just connect the projector by means of
the specific RJ45 connector located on the side of the DMX connectors and the relative patch to a common HUB Ethernet which will be connected
to an ArtNet controller. Each
Coemar projector has its own IP address, therefore it is not necessary to set it when connecting it to the network.
Should it be necessary to modify the IP address for reasons related to the net, each Coemar projector allows customization. In order to modify the
net setting, access the MAIN FUNCTION/PROJECTOR CONTROL MODE/ARTNET ONLY menu ( alternatively, Artnet to DMX) /CUSTOM IP
ADDRESS (see complete menu, art. 8.3).