The projector is able to operate at 200/208,230 or 240V at 50 or 60 Hz;
coemar
preselects
(barring specific requests), an operating voltage of 230 V and a frequency of 50 Hz.
The operating voltage of the projector is noted on the base of the unit, as shown in the
diagram.
If this preset voltage does not correspond with the conditions in your particular country of operation, follow the instructions in
the appropriate section of this manual, section
17. Altering the operating voltage and frequency.
Incorrect frequency and voltage selection will detrimentally affect the operation of the projector and immediately void the warranty.
mounting
Fiera
1200
may be suspended or floor mounted.
For the purposes of floor mounting,
Fiera
1200
is fitted with four pads on the base.
For suspending the fixture from lighting truss,
coemar
has included two cam-lock devices (
A
).
The two cam-lock devices may be instal-
led in 2 diverse positions on the base of
the
Fiera
1200
. These devices are 1/4
turn units. To install them, make sure that
they are correctly seated into the appro-
priate slots in the base of the unit.
If the fixture is to be suspended, we recommend the use of appropriate C clamps which are capable of comfortably sustaining
the weight of the fixture.
The C-clamps are fitted to the central shaft of the cam-lock devices.
The structure from which the unit is hung should be of sufficient rating to hold the weight of the unit and should also be suffi-
ciently rigid so as to not move or shake whilst the
Fiera
1200
moves during its operation.
Attention
Always use 2 clamps to suspend the projector
Posizione 1 / Position 1
Posizione 2 / Position 2
A
A
A
6. Mechanical installation
factory set main at:
208V
230V
240V
50Hz
60Hz
5. Operating voltage and frequency
29
English