8
5. Operation (See the front panel)
ATTENTION:
The protection class of POWER STICK 200K DC Inverter Arc Welder is IP21S. It is
forbidden to put in a finger or insert a round bar less than 12.5 mm (metal bar in particular) into the welder. No
heavy force can be employed on the welder`
1.
welder ’s handle
2.
Power Indicator
3.
Alarm Indicator
4.digital current
indicator
5.
Current Output “+”
Electrode Quick
Connector Socket
6. Potentiometer wire
7.
Welding Current
Adjustment Knob
8. Current Output “-”
Electrode Quick
Connector Socket
9.
On-off Switch
10.
Power Input Wire
Attention:
* The ‘protection indicator light’ will be on after a long time operation, it shows that the inner temperature is over
the permitted data, then the machine should be stopped using for some time to let it cool down. It can continue
using after the ‘protection indicator light’ is off.
* The power source should be switched off after the operation or while temporarily leaving job site.
* Welders should dress canvas work cloth and wear welding mask to prevent the hurt from arc and thermal radiation.
* Light separating screen should be put in the job site to prevent the arc will hurt other people.
* Inflammable or explosive materials are prohibited to access the job site.
* Each connection of the welder should be connected correctly and creditably
Basic Welding Procedure
a
˅
Connecting the power source switch,
Ǐ
Power Indicator Light
ǐ
bright
˗
b
˅
Regulate the welding current potentiometer to reach the value for welding;
c
˅
Take-up the torch hand, aim at the welding seam, use the stick contact with the work piece and then the electric
arc was ignited, i.e. you can effect the arc welding at the same time the
Ǐ
Welding Indicator Light
ǐ
bright.
Cali
Teléfono: (2) 3351214
Carrera 31 A # 10 A - 129
[email protected]
Bogotá
Teléfono: (1) 7433131
Calle 18 # 25 - 41
[email protected]
codinter.com
