A. Replace existing cam lock with KL1000 NetCode
1. Remove existing cam lock.
2. Place the 16mm (5⁄8") template hole over the hole left by the cam lock and mark the upper fixing hole.
3. Drill the 6mm (1⁄4") fixing hole.
4. Fit the KitLock to the door by passing the spindle through the 16mm (5⁄8") hole.
5. If required, from the inside of the door, pass either of the packing pieces over the spindle to centralise the
lock.
6. Now secure the lock by threading the large nut onto the spindle.
7. Fit one of the upper fixing bolts to suit your door thickness.
8. Tighten the lower fixing nut and upper bolt.
9. Select the cam which suits your door and frame and attach it to the square shaft at the end of the spindle.
10. Now check the operation of the lock using the factory User Code 2244.
11. If the lock is functioning correctly, CHANGE THE DEFAULT MASTER CODE 11335577 AND
DEFAULT USER CODE 2244 and program the lock using the programming and operating instructions
found at
B. New Installation
1. Place template on door and mark upper 6mm (1⁄4") hole and lower 16mm (5⁄8") hole.
IMPORTANT NOTE: Before drilling fixing holes, please ensure the position of the KitLock when fitted
will allow enough clearance for selected cam to work.
2. Drill both fixing holes.
3. Continue to installation from 4 to 11 above.
GSII-KL1060NC-v2:0416
© 2018 Codelocks Ltd. All rights reserved.
