Code WingMan Flex Series, Инструкция по установке и эксплуатации

Страница: 7 / 12

Page 7 of 12
Scene Steady ArrowStik Pattern ArrowStik Speed
All Primary Build - DEFAULT 0
All Secondary - DEFAULT Build 3 Flash 1
Travel 3 Flash 2
Build / Collapse 3
ArrowStik Overrides All Other functions
Scene Steady Overrides L1 & L2 Flashing
Changing Flash Patterns:
To change the flash patterns on the LED Light Heads, remove the mounting screws that attach the Cover to gain access to the printed circuit
boards inside (see the exploded view on page 11). Momentarily short and release the pattern change prongs as shown below to change
patterns. Carefully replace the cover and fasten cover mounting screws.
Note: Be extremely careful to replace the wiring such that you don’t pinch a wire when you replace the cover. Test the unit to be
sure that it works as intended.
JP1
1. Momentarily short and release
to change patterns.
2. Hold for 5 seconds to reset the
flash pattern to the first pattern.
Directional Module Flash Pattern
Cycle Flash-70 - (DEFAULT) Variable Flash Single
NFPA Quad Flash-80 Cycle Flash-150
Quad Flash-70 Five Flash-150
Steady Burn Quad Flash-150
Five Flash-70 Triple Flash-150
Triple Flash-70 Double Flash-150
Double Flash-70 Single Flash-150
Single Flash-70 Single Flash-250
Quad Pop Flash-70 Single Flash-375
Triple Pop Flash-70
Torus 3LED PCB Shown
Flash Pattern Header for Torus