Code WingMan Flex Series, Инструкция по установке и эксплуатации

Страница: 3 / 12

Page 3 of 12
Notes:
1. Larger wires and tight connections will provide longer service life for components. For high current wires it is highly recommended
that terminal blocks or soldered connections be used with shrink tubing to protect the connections. Do not use insulation displacement
connectors (e.g., 3M Scotchlock type connectors).
2. Route wiring using grommets and sealant when passing through compartment walls. Minimize the number of splices to reduce voltage
drop. All wiring should conform to the minimum wire size and other recommendations of the manufacturer and be protected from moving
parts and hot surfaces. Looms, grommets, cable ties, and similar installation hardware should be used to anchor and protect all wiring.
3. Fuses or circuit breakers should be located as close to the power takeoff points as possible and properly sized to protect the wiring and
devices.
4. Particular attention should be paid to the location and method of making electrical connections and splices to protect these points from
corrosion and loss of conductivity.
5. Ground termination should only be made to substantial chassis components, preferably directly to the vehicle battery.
6. Circuit breakers are very sensitive to high temperatures and will “false trip” when mounted in hot environments or operated close to their
capacity.
It is advisable to leave an extra loop of cable when installing the light bar to allow for future changes or reinstallations.Connect the wires in
the cable for the WingMan Flex Version you are installing as shown in the following diagrams.
Wiring Instructions:
IMPORTANT! This unit is a safety device and it must be connected to its own separate, fused power point to assure its continued operation
should any other electrical accessory fail.
All Multi Color, Single Color & Multi Color / Single Color Combinations, excluding MINI Single Color Version:
FLASH PATTERN CONTROL WIRES
POWER/GROUND CONNECT WIRES TO +12VDC TO PERFORM FUNCTIONS LISTED
RED WIRE----------------------- POWER +12VDC GREEN WIRE------------------- ARROWSTIK RIGHT
PROTECT WITH 20 AMP FUSE
WHITE WIRE---------------------- ARROWSTIK LEFT
BLACK WIRE------------------- GROUND WIRE
GREEN + WHITE------ ARROWSTIK CENTER OUT
PURPLE WIRE------------------ ARROWSTIK FLASH
LIGHT BLUE WIRE----------- SCENE LIGHTS
BLUE WIRE---------------------- DIMMING
YELLOW / BLACK WIRE --- SEQUENCE SELECT
YELLOW WIRE----------------- RATE SELECT
BROWN WIRE------------------ LEVEL 1 FLASH
ORANGE WIRE----------------- LEVEL 2 FLASH
LONG
VERSION
LIGHT BAR CABLE
SHORT
VERSION
MINI
VERSION
WINGMAN FLEX WIRING
MULTI COLOR, SINGLE COLOR & MULTI COLOR / SINGLE COLOR
COMBINATIONS ALL VERSIONS EXCEPT MINI SINGLE COLOR VERSION
FOR MINI SINGLE COLOR VERSION SEE TOP OF PAGE 17
SEE FUSING RECOMMENDATION