9
C005383_10 CR80XX Integration Guide
2.8 – CR8000 Decoded Scan Engine with Bracket Specifications
(continued)
2.9 – Enclosure Specifications
Non-Threaded Mounting Holes
There are two 2.50 mm diameter non-threaded
mounting holes on the CR8000 bracket,
shown below.
1. The enclosure for the CR8000 should be sufficiently large enough
to accommodate the engine and allow air flow to maintain safe
temperatures. The enclosure should minimize infiltration by
airborne contaminants and foreign materials.
2. The CR8000 must not come in contact with water.
3. The CR8000 is sensitive to Electrostatic Discharge (ESD) and must be
handled appropriately. Any individual that handles the CR8000 should
be grounded using a wrist strap and ESD protected work area and
work surface.
4. The warranty of the CR8000 is void if the recommendations above are
not followed when handling or integrating the device.
Threaded Mounting Holes
There are four M2 threaded mounting holes
on the CR8000 bracket, shown below. We
recommend using a M2X5 machine screw
for mounting.
3.24
[.128]
33.09
[1.303]
17.35
[.680]
2X 2.50 [.098]
± .07 THRU
3.24
[.128]
33.09
[1.303]
17.35
[.680]
2X 2.50 [.098]
± .07 THRU
28.09
[1.110]
26.24
[1.030]
8.42
[.330]
8.44
[.330]
11.23
[.440]
12.22
[.480]
18.24
[.720]
6.27
[.250]
1.85
[.070]
UNITS = MM [INCHES]