Code Blue
•
259 Hedcor Street
•
Holland, MI 49423 USA
•
800.205.7186
•
www.codeblue.com
GU-156-I
page 16 of 26
CB 6 Series
Administrator Guide
11 CB 6 Series Pole Mount Installation Instructions
1.0 THREAD MOUNTING STRAPS THROUGH SLOTS
– Use outside slots for larger poles and inside
slots for smaller poles.
2.0 HOLD BRACKET TO POLE
– Set the height of the bracket
(C)
so that the speakerphone push
button(s) on the unit will be at desired height (please check with local codes for ADA compliance).
3.0 BAND THE BRACKET TO THE POLE AT DESIRED HEIGHT
3.1 To eliminate waste, pull band
(A)
from carton as needed. With ears of buckle
(B)
away from
operator, slide the buckle on the banding. Lace banding around the object being clamped and
again through buckle.
3.2 Bend end of band under buckle.
3.3 Slide band in tool nose slot. Press down on gripper with thumb and tension clamp by turning
the handle. Maximum tension has been reached when the band stops moving through the
buckle.
3.4 When maximum tension has been reached, roll tool over buckle, at same time reversing handle
carefully at approximately three-quarters turn to avoid breakage. The band that is released will
be used in the bend and therefore there is no loss of tension.
3.5 Lift cutter lever and the band will be cut to correct length.While holding the stub of the band
with your thumb, hammer flat over bridge of buckle.
3.6 Complete application by hammering the buckle ears over the stub.
4.0 ATTACH ENCLOSURE TO BRACKET
4.1 Place a rubber washer
(D)
on each of the four studs.
4.2 Align and place the back plate of the unit over the four studs.
4.3 Place a second set of rubber washers on each of the four studs (inside the unit).
4.4 Place a steel washer
(E)
on each of the four studs.
4.5 Turn a nut
(F)
on each of the four studs.
Specifications subject to change without notice or obligation on the part of the manufacturer.
Banding tool sold
separately on the
Parts Order Form,
part #41441.
