Code Blue
•
259 Hedcor Street
•
Holland, MI 49423 USA
•
800.205.7186
•
www.codeblue.com
GU-158-M
page 33 of 50
CB 5 Series
Administrator Guide
20 CB 5 Overhead Camera Mount Installation Instructions
TOOLS REQUIRED
INSTALLING THE OVERHEAD CAMERA MOUNT
The camera mount will come with a gasket already mounted to the bracket on the arm. Place the bracket over
the mounting holes and insert the four 3/8-16 X 1 stainless bolts. (The 3/8” stainless steel bolts should have
one stainless steel washer and one rubber washer.) Verify the camera mount is evenly positioned to ensure
the gasket seal is properly seated. Tighten the bolts with your 3/8” wrench in a crisscross pattern to ensure
even pressure until it is snug against the outside of the pedestal.
INSTALLING THE CAMERA
Camera and wiring (supplied by others) is installed into the male 1½ NPT.
NOTE: If you are retrofitting an existing unit, the Overhead Camera Mount must be set in the desired position on
the side of the bollard with the four holes marked for drilling and tapping. Once the holes are marked, they will
need to be drilled and tapped to receive the 3/8” course thread stainless steel bolts. A 2” hole will need to be
drilled out of the center of the four holes for the camera wiring. (Mount bracket on the opposite side of the phone
opening, lining up with the center of the phone opening.)
Ladder
Access Panel
Security Bit
3/8Wrench
DRILL ONE
2” DIA HOLE
FOR WIRING
IN LINE WITH PIPE
