13
Negative Lock Output (GREEN)
Negative Unlock Output (BLUE)
Negative Second Door Unlock Output (BLUE/GREEN)
One Wire Positive Multiplexed and One Wire Multiplexed With 2-step Unlock Feature
All Door Lock and Unlock: Locate the lock / unlock wire at the vehicle’s lock / unlock switch.
Verification:
This wire will show variable positive voltage when the switch is activated. Please consult the
Vehicle Wire Color and Location Chart
for specific resistor values for your vehicle.
Driver’s Door Unlock: Locate the unlock motor wire directly from the actuator inside the driver’s door.
Verification:
This wire will rest at ground and register positive voltage when the driver’s door is unlocked.
Connect the GREEN and BLUE or BLUE/GREEN wires shown in the diagram below using (2) SPDT
relays (not supplied).
Note: When adding the 2 step unlock feature the BLUE/GREEN 2nd door unlock wire will be used to unlock
all vehicle doors on the second press of unlock. An additional SPDT relay (not supplied) is required.
Connect the relay as shown in the diagram below to unlock the driver’s door on the first press of unlock.
4. 3 PIN HARNESS
Lock
Unlock
87
87a
86
85
30
Vehicle Door Lock
Control Relays
GREEN (-) Lock Output
BLUE (-) Unlock Output or
BLUE/GREEN 2nd Unlock
Output for 2 Step Unlock
For 2 Step Unlock:
Fused +12 Volt
Battery Souce
BLUE (-) Unlock Output
From Keyless Entry
Module or Door
Unlock Relay
Drivers Door
Unlock Motor Wire
X
Cut
Multiplex Locks:
87
87a
86
30
87
87a
86
30
85
85
Fused +12 Volt
Battery Source
Resistor
