Using Your Remote Control
Arming the Security System
To arm the system, exit the vehicle, close all doors, then press the LOCK
icon button on the remote control. The system will sound twice and the
parking lights will flash twice, indicating the system is armed. The doors will
also lock at this time (if equipped and connected). The status indicator (blue
warning light on the dash) will blink steadily, once per second. To arm the
system silently, press and hold the LOCK icon button for 1 second. The
parking lights will flash 2 times indicating the system is armed and has locked
the doors (if equipped and connected). The status indicator (blue warning light
on the dash) will blink steadily, once per second.
Pre-arm Mode
If the horn system sounds and the parking lights flash only once, this indicates
that the vehicle’s interior light is on or an entrance is left open. Check to see that
all doors hood and trunk are closed properly. Once all entrances are secured (and
the interior light is off), this system will sound/flash again. The system is now fully
armed. (If the entrance is not secured within 4 minutes, the system will arm and
ignore the unsecured entrance until it is closed.)
Disarming the Security System
To disarm the system press the UNLOCK icon button. The system will sound, the
parking lights will flash once and the doors will unlock (if equipped and
connected). To disarm the system silently, press and hold the UNLOCK icon button for 1 second. The
parking lights will flash, indicating the system is disarmed and has unlocked the doors (if equipped
and connected).
Disabling/Enabling Confirmation Chirps
1. Turn the ignition key ON then OFF.
2. Within 10 seconds push and release the valet/override button 3 times.
3. The system will sound 2 times to disable confirmation chirps or 1 time to enable confirmation
chirps.
.
Attempted Intrusion Identification
This system will inform you if an intrusion attempt has occurred while you were away from the vehicle. If
an intrusion attempt occurred, the system will sound 4 times and the parking lights will flash 3 times
when disarming the system. Enter the vehicle an observe the dash mounted status LED to Identify
which zone was triggered.
1. IT-s Sensor- 1 flash, pause 1 flash, etc.
2. Hood or Trunk Pin switch- 2 flashes, pause 2 flashes, etc.
3. Door Entry- 3 flashes, pause 3 flashes, etc.
The intrusion warning indicators are stored in the system’s memory and will be erased when the ignition
key is turned on.
Two Stage Door Unlock (Optional)
If this feature is enabled on your system, pressing the UNLOCK icon button one time on the remote
control will unlock only the driver’s door. Press disarm again to unlock the remaining doors.
Activating the Trunk Release Feature (Optional)
If this feature is enabled on your system, pressing and holding the TRUNK icon button on the remote
control for 2 seconds will open the vehicle’s trunk or hatch.
*Throughout this manual, ‘press’ refers to pressing for less than 1 second; ‘press and hold’ refers to pressing for more
than 2 seconds.
3
