Code 3 CODE 360, Руководство по установке и эксплуатации

Страница: 13 / 24

13
Figure 7
The following are optional features that may or may
not be included in your control head depending upon
which model you purchased.
"Fast Speed" Mode: Fast speed and Dim Modes
are combined. Pushing the button marked "Fast" will
cause each of the 4 patterns of the ArrowStik to
operate at a faster rate, with the same amount of light
intensity.
"Dim" Mode: Dim and Fast speed Modes are
combined. Pushing the button marked "Dim" will
cause each of the 4 patterns of the ArrowStik to
operate at a lower intensity level. This is for use at night
when 100% intensity is too much, or daytime when current
draw needs to be reduced.Bayonet Style: Push down and turn to
remove lamp. Install a new lamp the same way. (SEE FIGURE 7)
Note: If attempting to clean the reflector, use only a mild glass cleaner and a very soft cloth. Do not attempt to use any wax type
products as these will burn onto the reflector.
Changing Lower Unit Lamp and/or Filter
Refer to Figure 10. Remove the reflector assembly by removing the appropriate fasteners, then remove the snap-on filter if
necessary. In most cases, these lamps will be a bayonet style, so simply push in and turn counterclockwise to remove.
Replacement for Upper and Lower Level Components
See exploded view "Parts Section" for fastener removal, component location, and assembly
configuration. Caution, extreme care must be taken when installing components to prevent pinching wire connections
and to avoid interference with moving assemblies.
!
WARNING!
High voltages and/or temperatures are present inside the unit. Disconnect from power and wait 10 minutes
prior to servicing or troubleshooting. Use hand and eye protection when changing halogen lamps or
flashtubes.
Strobe Filter Replacement
Refer to figure 8. The filter can be removed by unsnapping it from the light head and by removing the mirror if present for clearance. Prying
the filter from the front may damage the glass strobe tube or reflector.
To replace the filter, reverse the above procedure. The filter should be fully engaged on the light head assembly. Care should be taken to
not damage the strobe tube or to scratch the reflective surface of the reflector when replacing the filter.
Strobe Light Head Replacement
Refer to figure 8. Disconnect the light head assembly wiring from the strobe power supply and remove the filter if any. Unfasten the screws
attaching the light head mounting bracket to the light bar chassis and remove the light head from the light bar. On a bench or other work
suitable work surface unfasten the screws attaching the strobe light head assembly from the light head mounting bracket. Install the new
strobe light head assembly to the light head mounting bracket and reinstall the light head back onto the light bar chassis. Reconnect the light
head wiring to the strobe power supply and reattach the filter. It is important to reroute and secure the wiring as close as possible to its
original position.
Caution, verify that no wires are interfering with the operation of the fan located at the end of the power supply.