EN
G
LI
S
H
7
3
4
8
9
15
15a
Operating instructions
Warning:
• Always unplug the planer before adjusting the cutting depth or cutting width.
• Make sure that the workpiece is securely fastened to the work bench and that
the work bench is stable and won’t move.
• Lower the parking rest on the rear
of the planer when you stop work.
It protects the blade when it is not
in use.
Planing a flat surface
Turn the planing depth adjuster (8) to the desired depth. Plug the planer into the wall
socket. Hold in the trigger lock button (5) and then pull the power trigger (6).
Warning:
Never adjust the planing depth while planing; doing so will result in
an uneven depth of cut. Always return the planing depth to 0 when you have finished
work to avoid an incorrect setting when beginning your next planing task.
Rebating
Attach the parallel guide (15) as shown
in the figure above and fasten it using
the locking knob (9).
Adjusting the rebating depth
Set the rebating depth guide (3) to
the desired depth and lock it using
the locking lever (4).
Adjusting the cutting depth
Turn the planing depth adjuster (8) to the desired setting.
Warning:
Never adjust the planing depth while planing; doing so will result in an une-
ven depth of cut. Always return the planing depth to 0 when you have finished work to
avoid an incorrect setting when beginning your next planing task.
Adjusting the rebating width
The rebating width is adjusted using the parallel guide. Loosen the wing nut (15a), set
the parallel guide to the desired position and then tighten the wing nut again.
