Cocraft 18-3630, Оригинальное руководство пользователя

Страница: 11 / 60

EN
G
LI
S
H
11
Drill mode
Set the torque/drill mode selector ring (7) to drill mode.
High / Low gear
The gear selector (8) has two settings:
Position 1: 0–400 rpm, position 2: 0–1500 rpm.
Changing drill and screwdriver bits
The drill/driver has a keyless chuck which enables drill or screwdriver bits to be
changed with one hand. Twist the chuck to the left to tighten, to the right to untighten.
Make sure that the bit sits centred and secured in the chuck.
Drilling tips and advice
• When drilling into slippery materials, like tiles, you should place a strong piece of
tape on the area in which you wish to drill to prevent the bit from wandering.
• When drilling into metal you should first use a centre punch to make a small
indentation at the spot where you wish to drill. This indentation will help hold
the bit in place and prevents it from wandering when you drill.
• When drilling into metal you should also use cutting oil to assist in drilling and to
preserve the machine and drill bit.
• Always use a clamp or vice to hold the workpiece.
• When drilling into walls, make sure not to damage water pipes, electricity cables
or gas pipes.
Screwdriver mode
Use the torque/drill mode selector ring (7) to set a suitable torque setting. The correct
torque setting will disengage the drive at the preset torque to prevent screws from
being over-tightened or driven in too far. The setting should be based on the type and
size of screw and the material being screwed into. Always start at the lowest setting
and increase in increments to find the correct setting.
Care, maintenance and storage
Drill/driver
• Always remove the battery from the drill/driver before cleaning it and putting it away.
• Clean the exterior of the drill/driver with a soft brush or cloth. Never use water,
solvents or corrosive chemicals for cleaning.
• Regularly remove all dirt, especially from around the motor ventilation slits (9).
• Store the drill/driver in a dry place out of children’s reach whenever it is not to be
used for a long time.
• The battery should be stored in an ambient temperature of 5–50 °C.
• Charge the battery fully every six months to maintain the battery capacity.