Cocoon HE170543, Инструкция по эксплуатации, Страница: 10 / 20

10
After Sales Support
1300 663 907
Model Number
HE170543
customercare@winplus.com.au
.
Dash Monitor Installation
1.
Stick the Suction Cup Mount on the windshield and adjust to your desired position.
2.
Hook the Dash Monitor on to the windshield mount.
3.
Remove the Dash Monitor protective overlay.
4.
Now power the monitor:
a. 12V/24V Power Adapter
Take the 12V/24V Power Adapter and plug adapter into the right side of the Dash Monitor. Plug the
other end into 12V/24V power port in your car.
b.
Hard Wire (Optional)
Take the Hard Wire Power Adapter and plug adapter into the right side of the Dash Monitor. Run cable
to fuse box and connect to fused accessory power source. Refer to your vehicle owner manual for
location of available accessory fuses.
5.
The Dash Monitor is ready to be automatically powered on when the vehicle engine starts.
WARNING: Many vehicles provide constant power to the 12V outlet. If your outlet provides constant power,
please remember to unplug the monitor when not in use to avoid draining the vehicle battery.
Magnetic Mount Option
The camera has a strong magnet on its back and can be mounted on most metal surfaces of a vehicle, trailer,
or anything you tow. The camera is already charged,
but it is good practice to charge the camera when not in
use. The camera will fully charge in 5 hours.
The desired mounting place has to be a clean and flat
surface to provide maximum magnetic holding force.
Aluminium / plastics / carbon fiber will not hold the
magnetic camera. Turn the camera on or off using the power button on the top of the camera. The camera
image will always appear on the monitor screen as long as both are receiving power.* It is recommended
to remove the camera when not in use and charge fully between uses. The camera provides 4-5 hours
of viewing time between charging. When the battery on the camera is at 20%, an icon will appear on the
monitor to notify you.
The camera is not intended to be mounted permanently. It is recommended to remove the camera when not
in use and fully charge between uses. There are strap holders on each side of the camera. Use tie-wraps or
rope to secure if needed.
Installation