When reinstalling the battery cap, lightly lubricate the O-rings and slowly
twist the cap into place using a coin (US Quarter supplied). Press the coin
into the battery cap slot firmly to prevent slipping and damaging the slot.
Ensure there is no dirt or debris on the O-rings or the mating surface and
that the O-rings are properly installed.
As the battery cap is screwed in, carefully observe that the double O-rings
install correctly.
It is best to have the new batteries ready to install since the EMC-16 was
designed to allow for battery changes without resetting. This period of
time is typically 30 seconds, but varies with temperature and the voltage of
the batteries being replaced. It can be significantly less if batteries are not
replaced promptly when the ‘BATT’ legend first comes on. Again care
should be taken not to activate the TACLITE™ during battery replacement,
if the TACLITE™ is activated it will significantly reduce the time that the
EMC-16 allows for battery changes.
If the batteries are allowed to discharge too low, or if removed for too long,
the EMC-16 may enter a state where it will not turn on even with new
batteries. If this occurs, remove the batteries and allow the unit to set for
60 minutes and then install fresh batteries. This procedure will affect the
internal Time of Day Clock’s settings and these settings should be verified
via the Analyst
®
P.C. Interface.
CAUTION!!!
COMPLETE LOSS OF BATTERY POWER MAY CAUSE
ALL PREVIOUS DIVE NITROGEN LOADING TO BE LOST. THIS WILL
AFFECT NITROGEN CALCULATIONS ON NEAR-FUTURE DIVES.
AFTER A BATTERY CHANGE, CONFIRM THAT NO-DECOMPRESSION
TIME DATA IS REASONABLE IN THE PRE-DIVE PREDICTION MODE.
DIVE-OF-DAY NUMBER GOING TO ZERO IMMEDIATELY AFTER
CHANGING BATTERIES IS ANOTHER INDICATION OF A LOSS OF
NITROGEN LOADING.
ASSISTANCE, REPAIR & MAINTENANCE:
The Cochran EMC-16 does
not require an Annual Maintenance, but if you suspect that your EMC-16 is
not operating correctly, please contact our Customer Support Department
in the USA for assistance at 972.644.6284 or FAX details to 972.644.6286
or E-mail details to [email protected]. Most problems can be
resolved without returning the unit. The unit may also be returned to the
place of purchase and request the dealer to contact us. If this is not
possible or is inconvenient due to a change in location, contact us for the
name of the nearest Team Cochran Authorized Dealer.
•
NEVER TEST OR SUBJECT THE PRODUCT TO PRESSURIZED AIR! (Voids
Warranty)
•
NEVER REMOVE THE LENS FROM THE UNIT! (Voids Warranty)
•
ONLY USE FRESH WATER TO CLEAN UNIT! NEVER USE SOLVENTS!
•
DO NOT USE A SCREWDRIVER TO REMOVE BATTERY CAP! (Voids
Warranty)
•
ALWAYS KEEP FRESH BATTERIES INSTALLED!
•
LUBRICATE BATTERY ENDS WITH THIN FILM OF SILICONE GREASE!
ANALYST
®
Personal Computer Interface
The ANALYST
®
Personal Computer Interface is a complete
hardware/software system that uploads data from the Cochran EMC-16 to
a Personal Computer with a Windows
®
operating system. The ANALYST
®
Personal Computer Interface allows the diver to retrieve dive data,
customize the dive computer and also to enter and store information for
each dive in a logbook database.
FCC LABEL
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
INTERFERENCE STATEMENT
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device. If not installed and used in accordance
with the instructions, it may cause interference to radio communications.
The limits are designed to provide reasonable protection against such
interference in a residential situation. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause interference to radio or television reception, which can be
determined by turning the equipment on and off, the user is encouraged to
try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna of the affected radio or
television.
•
Increase the separation between the equipment and the affected
receiver.
•
Connect equipment and the affected receiver to power outlets on
separate circuits.
•
Consult the dealer or an experienced radio/TV technician for help.
MODIFICATIONS
Changes or modifications not expressly approved by Cochran Consulting,
Inc. could void the user's authority to operate the equipment.
SHIELDED CABLES
This product is designed to be used only with the Analyst
®
USB interface
module and cable to maintain compliance with FCC Regulations.
PATENT INFORMATION
Protected under one or more Foreign or US patents.
5,899,204
5,794,616
5,617,848
5,570,688
Other patents may be pending.
All specifications subject to change without prior notice. Analyst
®
is a
registered trademark of Cochran Consulting, Inc.
Energizer
is a registered
trademark of the Eveready Battery Co., St. Louis MO. Copyright 2002
Cochran Consulting, Inc.
CE
The CE mark is used to mark conformity with the European Union EMC
directive 89/336/EEC. Cochran dive instruments fulfill all the required EU
directives.
PREN 13319
PREN 13319 “Diving accessories – Depth gauges and combined depth
and time measuring devices – Functional and safety requirements test
methods” is a European diving depth gauge standard draft. Cochran dive
instruments are designed and tested to comply with this standard draft.
LIMITED WARRANTY:
To the original purchaser ("OWNER") only,
Cochran Consulting, Inc. ("COCHRAN") represents this Product to be free
of defects in materials and workmanship under normal recreational SCUBA
use for 24 months from the original date of shipment from COCHRAN.
Units that are used for Rental, Commercial, or Military purposes are
warrantied to be free of defects in materials and workmanship for 12
months from the original date of shipment from COCHRAN. For purposes
of establishing warranty eligibility, this date of shipment may be noted on
the original Product box, or can be determined by contacting COCHRAN.
Any defective Product, unless cause is specifically excluded in the
"Warranty Conditions and Limitations" section below, will at the sole
discretion of COCHRAN, be repaired or replaced with a new or refurbished
unit of comparable or better function and/or condition. COCHRAN is not
responsible for any incidental or secondary damages as a result of Product
malfunction.
WARRANTY CONDITIONS and LIMITATIONS:
Product must have been
obtained from a COCHRAN Authorized Dealer or directly from COCHRAN.
Contact COCHRAN for verification of dealer status. This Limited Warranty
is not transferable.
The product must be registered with COCHRAN within 15 days of
purchase in order to validate Limited Warranty. The product can be
registered via the COCHRAN website
(http://www.divecochran.com/productregistration/productregistration.aspx).
Failure to provide proper care for this Product will render this Limited
Warranty null and void. Damages or malfunction resulting from accidental
or deliberate abuse, tampering, battery leakage, exceeding maximum
intended operating depth or other parameters, extreme heat or cold,
exposure to harmful chemicals such as hydrocarbons, or other conditions
which COCHRAN may deem to be outside the intended scope of this
Limited Warranty are not covered.
This Limited Warranty does NOT cover plastics, O-rings, batteries, battery
life, and flooded battery compartments.
This Limited Warranty will be rendered null and void if an attempt is made
to establish communications with the computer with any hardware and/or
software other than the COCHRAN approved Analyst
®
Interface.
The OWNER is responsible for shipping this Product to COCHRAN for
service, and paying all associated costs, including shipping, insurance, and
import duties. OWNER may take Product to an Authorized Dealer to
arrange service under terms of this Limited Warranty. COCHRAN will
return Product to US OWNER or US Dealer via a method and carrier of its
choosing. Costs for requested expedited return shipping will be the
responsibility of OWNER. Product returned for service under terms of this
Limited Warranty must be accompanied by a photocopy of the original
sales receipt in order for warranty repair or replacement to be performed if
the Warranty Registration is not on file.
1 1
