Wall Mounting Instructions
The following steps enable installation on a new or existing telephone wall-
mounting plate or directly onto a wall.
(Your Cobra INTENNA is designed
to be used with any AT&T, GTE, local phone company or other wall-mount-
ing plates that can be purchased from most local electronics stores.)
•
Press telephone cord into slots under the base and wrap around cord-
storage area (as shown in diagram #2, below).
•
Plug modular phone connector into telephone wall jack; attach the
power adapter to the POWER connection (on the base of the phone) and
plug into to a household AC power outlet.
•
Align mounting studs on the plate to the holes on the bottom of the
INTENNA base; push base onto studs and slide down on the wall plate.
To install directly on any wall, you’ll need to provide two screws and wall
anchors; follow these steps:
•
Drill two holes 3
1
/
4
” apart and insert the wall anchors.
•
Drive the screws into the anchors until the head of each screw is
protruding about
1
/
8
” from the wall.
•
Align the holes in the cordless base over the screw heads; push base
in and slide down on screws (see diagram #3).
•
Plug modular phone connector into telephone wall jack; attach the
power adapter to the POWER connection (on the base of the phone; see
p. 4) and plug into to a household AC power outlet.
Note:
Make sure you have charged the handset at least 12 hours before use.
5
Screw Heads
Diagram #3:
Installation
directly on a wall
Mounting Studs
Diagram #2:
Installation on a
telephone wall-
mounting plate
Cord
Storage Area
Modular Phone Jack
Modular Phone Jack
