Cobra CSP6, Инструкция по установке и эксплуатации

Страница: 8 / 19

6
NOTE:
It is most important that this appliance is installed
correctly and that operation is correct before use.
Installation shall comply with local, gas, health and
safety requirements.
This appliance shall be installed with sufficient
ventilation to prevent the occurrence of
unacceptable concentrations of health harmful
substances in the room, the appliance is installed in.
Cobra Gas Stock Pots are designed to provide
years of satisfactory service and correct installation
is essential to achieve the best performance,
efficiency and trouble-free operation.
It is strongly recommended that the appliance is
installed under an extraction hood with a minimum
clearance of 1200mm to the grease filter.
This appliance must be installed in accordance with
National installation codes and in addition, in
accordance with relevant National / Local codes
covering gas and fire safety.
Australia / New Zealand:
AS/NZS 5601- Gas Installations.
Installations must be carried out by qualified service
persons only. Failure to install equipment to the
relevant codes and manufacturer’s specifications
shown in this section will void the warranty.
Components having adjustments protected (e.g.
paint sealed) by manufacturer, are only to be
adjusted by a qualified service agent. They are not
to be adjusted by the installation person.

Remove all packaging and transit protection
from the appliance including all protective
plastic coating from the outer panels and
exterior stainless steel panels.

Check the equipment and parts for damage.
Report any damage immediately to the carrier
and distributor.

Report any deficiencies to the distributor who
supplied the appliance.

Check that the available gas supply is correct to
that shown on the rating plate located on the
lower RH Side of the appliance.
1. This appliance must be installed in a suitably
ventilated room to prevent dangerous build up
of combustion products.
2. Installation must allow for a sufficient flow of
fresh air for the combustion air supply.
3. The appliance must be installed on a fire proof
base.
4. Position the appliance in its approximate
working position.
5. All air for burner combustion is supplied through
the base area of the appliance. Refer to tables
in Gas Conversion and Specifications Section.
6. The legs must always be fitted and no
obstructions placed on the underside or around
the base of the appliance, as obstructions will
cause incorrect operation and / or failure of the
appliance.
7. Components having adjustments protected
(e.g. paint sealed) by manufacturer are only
allowed to be adjusted by a qualified service
agent. They are not to be adjusted by the
installation person.
NOTE:
Only non-combustible materials can be used in
close proximity to this appliance.
To facilitate easy operation, drainage and servicing
of the Stock Pot, a minimum of 600mm clearance
should be maintained at the front of the appliance.
Any gas burning appliance requires adequate
clearance and ventilation for optimum and trouble-
free operation. The following minimum installation
clearances are to be adhered to:
LH / RH Side 250mm 0mm
Rear 0mm 0mm
Floor Base Non Combustable Fire Proof Base.
Natural Gas
18m³/hr min.
LPG / Butane
19m³/hr min.