12
NOTE:
All maintenance operations should only be carried
out by a qualified service person.
To achieve the best results cleaning must be regular
and thorough and all controls and mechanical
parts should be checked and adjusted periodically
by a qualified service person. If any small faults
occur, have them attended to promptly. Don't wait
until they cause a complete breakdown. It is
recommended that the appliance is serviced every
6 months.
The gas control valve should be dismantled and
greased every 6 months to ensure the correct
operation of the gas control valve.
To carry out this operation;-
a. Remove the gas control knobs from the gas tap
spindles by pulling the knobs away from the
control panel.
b. Remove the drip tray from the appliance.
c. Remove the two screws on the underside of the
control panel, securing the control panel to the
hob.
d. Remove the control panel from the front of the
appliance.
e. Remove the 2 screws holding shaft plate to gas
control body and remove control shaft and
plate. Note orientation of shaft for correct
re-assembly.
f. Using needle nose pliers or similar, pull out gas
control spindle, again noting its orientation.
g. Apply a suitable high temperature gas cock
grease or lubricant such as ROCOL - A.S.P (Anti
scuffing paste) / Dry Moly Paste to the outside of
spindle.
h. Replace spindle and re-assemble the gas
control in reverse order.
i. Refit the control panel to the appliance and
secure with 2 screws.
j. Refit the knobs to the gas control valve spindles.
Stainless Steel Surfaces
a. Clean the exterior surfaces of the barbeque
with hot water, a mild detergent solution and
a soft scrubbing brush. Note that the gas
control knobs are a push fit onto the gas
control valve spindles and can be removed
to allow cleaning of the front control panel.
b. Baked on deposits or discolouration may
require a good quality stainless steel cleaner
or stainless steel wool. Always apply cleaner
when the appliance is cold and rub in the
direction of the grain.
c. To remove any discolouration, use an
approved stainless steel cleaner or stainless
steel wool. Always rub in the direction of the
grain.
d. Remove the grease tray and clean with a
mild anti bacterial detergent and hot water
solution using a soft bristled brush.
e. Dry the grease tray thoroughly with a dry
cloth.
f. Dry all components thoroughly with a dry
cloth and polish with a soft dry cloth.
Two Screws
Spindle