3. Insert the hanging loop of collection bag into hook
(Fig. 2).
4. Align the connector on the collection bag with the outlet
nozzle, pin of outlet nozzle into slot of connector and
insert it all the way to the stop. Turn the connector
counterclockwise until the pin of outlet nozzle is locked in
the ring of connector .
Warning!
Always use the product with its collection bag attached when operating it to protect yourself against
projected debris and to avoid injuries! Do not use this product with a damaged collection bag or without one at
all! Switch-off the machine before attaching or removing the bag.
Connection to the power supply
1. We recommend that this equipment is only connected into a socket which is protected by a circuit-breaker
that would be actuated by a 30 mA residual current (RCD). Only use or replace power supply cables for this
unit with the same type. DO not run over, crush or pull the power supply cable or extension cable, otherwise it
may be damaged. Protect the cable from heat, oil and sharp edges. Use only extension cables suitable for
outdoor use, preferably with a high visibility cord color with the following specification:
For extension cables up to 25 meters, use a wire cross
section of 1.5mm
2
. For extension cables over 25 meters
and less than 40 meters, use a wire cross section of
2.5mm
2
.
2. Make sure the on/off switch (1) is in its off position.
Connect the plug with the extension cord socket .
3. Loop the cable through the hole on the rear safe
guard and hook the loop over the cord retainer. Gently
pull on the cord to ensure that it is firmly attached at the
handle (Fig. 3).
4. Connect the plug to the power supply.
5. Your product is now ready to be used by switching on (1 ).
Operating mode selection
Warning!
Always turn the product off and let it come to a complete stop before changing the operating mode!
1. Select the operating mode by moving the mode lever to the respective symbol.
2. Move the lever to the up position to use the product as a vacuum (Fig. 4).
8
