Cobra Beach Magnet Скачать руководство пользователя

Страница: 4 / 6

IN THE FIELD TIP FOR USING YOUR COBRA BEACH MAGNET

2. The Cobra Beach Magnet is an Ultra Slow Motion Metal De-
tector.

When using this detector the coil must be in motion to detect

any target. A sweep speed of about 2 feet per second is perfect.
You can hunt as fast as you want or as your pace dictates.

3. Correct arm position.

Adjust

the lower stem so that your arm
is hanging in a comfortable posi-
tion by your side with the coil
about 1 inch off the ground.

1. Always keep the bottom of the coil level with the ground.

Try

to maintain coil 1 inch off the ground at all times. You do not need
to scrub the ground with the coil.

FEET

PER

SECOND

OPERATION OF THE BATTERY TEST CONTROL –

Before testing the batteries

you must first make sure the

Volume Control

is set to its maximum position. Now you simply ro-

tate the

Detection Depth Control

counterclockwise until it "clicks

into the battery test mode", good batteries will give a loud audio
and very bright target light. If the batteries are getting weak you
will only get a faint audio volume and the target light will be dim. If
you can't  get any audio or target light when testing the batteries,
it is time to replace them. Use only alkaline type batteries for the
best performance and run time. You can also use good quality re-
chargeable  batteries,
but  run  time  will  be
somewhat less.

Testing the battery with the

Detection Depth Control

. . .

�

� � �

�

��

�

� � �

�

��

�

� � �

�

��

��

�

� � �

�

��

�

� � �

�

��

�

� � �

�

��

��

Locate the battery door cover

and

loosen  both  stainless  steel  screws
(see  inset)  remove  door  and  care-
fully  remove  (6)  "AA"  batteries  from
the  installed  battery  holder.  Replace
with  fresh  "AA"  batteries  and  please
pay  careful  attention  to  the  plus  and
minus direction of each battery. Place
holder back in battery box. Pay care-
ful attention to the rubber battery door
seal that it is properly aligned and not
pinched  between  door  and  battery
box  and  tighten  down  both  stainless
steel battery door screws.

Installing the Batteries:

Caution: DO NOT

Remove

the two wa-

terproof seal/strain relief's where the head-

phone wire and search coil wires exit . . .

Note:

DO NOT over tighten the screws!!