®
23801 E. La Palma Ave., Yorba Linda, Ca 92887 Ph. 714.692.8180 Fax. 714.692.5016
www.cobrausa.com
04/17
®
Instruction Manual >
602-2005/602-2005B
Page 2 of 3
5.
Repeat Steps 1-4 on the left side.
6.
Install the supplied side plates on to the sissy bar with the four M8 X 20mm button head bolts. Make
sure the u-shaped grommets are facing the same direction as the sissy bar pad and the part numbers
are facing inward. See
FIGURE 4
. Snug the bolts but DO NOT TIGHTEN at this time.
7.
Install the sissy bar onto the bike by first inserting the front portions of the side brackets on to the front
mounting bushings on the frame rails. Make sure the sissy bar is seated all the way onto the mounting
bushings. See
FIGURE 5.
8.
Then slowly rotate the sissy bar downward so the rear portions of the brackets slip over the rear
mounting bushings. See
FIGURE 5.
DOCUMENT NO. 0018
REV. A
CONTINUED ON PAGE 3
FIGURE 4
PART NUMBER
FACING INWARD
M8 X 20mm
BUTTONHEAD
BOLTS
M8 X 20mm
BUTTONHEAD
BOLTS
SISSY BAR
PAD
FIGURE 3
FRONT
MOUNTING
BUSHING
ASSEMBLED
SLEEVE, PLASTIC
BUSHING, AND
BUSHING SPACER
REAR
BUSHING
FIGURE 2
REAR
BUSHING
SPACER
5/16-18 X 2-
1/4”
BUTTONHEAD
REAR
BUSHING
SLEEVE
CHAMFERED
INNER EDGE