®
23801 E. La Palma Ave., Yorba Linda, Ca 92887 Ph. 714.692.8180 Fax. 714.692.5016
www.cobrausa.com
04/17
®
*
Cobra
®
recommends you always wear a helmet while riding. Please never operate your motorcycle while under
the influence of alcohol and/or drugs. Enjoy the new look of your motorcycle and please ride safely.
Items Supplied >
1 - Sissy Bar w/ Pad and Insert
2 - Detachable Side Plates (Left/Right)
2 - Front Mounting Bushings
2 - Rear Bushing Spacers
2 - Rear Bushing Sleeves
2 - Rear Bushing
2 - 5/16
”-18 x 2-3/4” Buttonhead Bolts
2 - 5/16
”-18 x 2-1/4” Buttonhead Bolts
4 -
M8
x 20mm Buttonhead Bolts
Application(s) >
HARLEY:
SPORTSTER
04-19
(NOTE: WILL NOT FIT 16-17 ROADSTER)
Instruction Manual >
Read all instructions carefully before installing your new Cobra
®
product!
1.
Remove the front bolt and inner nut from the right side fender rail. Save the inner nut because it will
be reused.
NOTE:
Remove one side only so the fender does not fall resulting in possible scratches or
damage to the fender or paint. See
FIGURE 1
.
2.
Install the front mounting bushing into the front hole using the supplied 5/16”-18 x 2-3/4” long
buttonhead bolt and stock inner nut. Tighten bolt securely. See
FIGURE 3
.
3.
Remove the rear fender rail bolt and inner nut. Save the inner nut because it will be reused. See
FIGURE 1
.
4.
Assemble the supplied plastic bushing over the sleeve as shown in
FIGURE 2
. Make sure the
chamfered inner edge goes towards the wide end of the sleeve.
5.
Install the bushing onto the rear of the frame rail by inserting the 5/16”-18 x 2-1/4” long buttonhead
bolt through the sleeve, through the supplied bushing spacer, and into the rear frame. See
FIGURE 3.
6.
Position the inner nut on the inside of the fender and tighten the bolt securely. Make sure the tab on
the inner nut goes into the hole on the inner fender.
602-2005/602-2005B
Page 1 of 3
DOCUMENT NO. 0017
REV. B
CONTINUED ON PAGE 2
FIGURE 1
REMOVE
REMOVE