Cobalt Digital Inc BBG-1034-AUD-PRO-DSP, Руководство по эксплуатации продукта, Страница: 73 / 118

BBG-1034-AUDPRO-OM (V1.6) BBG-1034-AUD-PRO-DSP PRODUCT MANUAL
3-41
Setup/Operating Instructions
BBG-1034-AUD-PRO-DSP Function Menu List and
Provides an audio crosspoint allowing the audio source
selection for each analog audio output channel. Also
provides Gain, Phase Invert, and Muting controls and
peak level meters for each output channel.
• Analog Output Channel Source Using the Source drop-down list, selects the audio input source to be
routed to the corresponding analog audio output channel from the
following choices:
• Audio Bus Ch 1 thru Ch 16
• Built-in Tone generators Tone n
(-20 dBFS level tone generators with n being frequencies of 100, 200,
300, 400, 500, 600, 700, 800, 900, 1k, 2k, 4k, 6k, 8k, 12k, and 16k)
• Flex Bus A thru P mixer sum node outputs
• Audio LTC
• Downmixer L
• Downmixer R
• Audio DSP n sources (route DSP output to device analog output)
Note: • Audio DSP source choices depend on Audio DSP asset(s) being
enabled and position at output mixer (see Audio DSP Setup
Controls (p. 3-10) for more information).
• Audio DSP choices that provide a PCM output are suitable for use
as an analog output source. Use care to avoid routing non-PCM
signals (such as Dolby pairs) to an analog output.
• Channel Mute/Phase Invert/Gain Controls
and Peak Level Display
Provides Mute and phase Invert channel controls, as well as peak level
meter for each output channel. (Meter shows level as affected by Level
control.)
Gain controls allow relative gain (in dB) control for each corresponding
destination analog audio out channel.
(-80 to +20 dB range in 1.0 dB steps; unity = 0 dB)
Table 3-1 BBG-1034-AUD-PRO-DSP Function Menu List — continued