Cobalt Digital Inc A25 BOWRIDER, Руководство пользователя

Страница: 112 / 126

Cobalt_OM_preprint_shell.fm Page 2 Wednesday, March 1, 2006 5:39 AM
6
-
2 A25 Owner’s Manual
COBALT
A25
BOWRIDER
S
ECTION
6
Break-In
Careful break-in allows internal engine components
to “seat” properly, resulting in maximum engine life
and performance. Refer to the propulsion unit and
generator (if equipped) operator’s manuals for
manufacturers’ break-in requirements.
Before Each Use
1. Test for proper operation of the carbon
monoxide detector (if equipped); refer to the
carbon monoxide detector operator’s manual.
2. Check fluid levels of freshwater tank, waste
holding tank (if equipped) and trim tab reservoir.
3. Check the air conditioning and generator (if
equipped) seacocks and hoses for leaks. If you
notice a leak, see your authorized Cobalt
dealer.
4. Check the air conditioning and generator
seawater strainers for leaks and accumulation
of debris.
• If a hose is leaking or damaged, close the
appropriate seacock. Consult your authorized
Cobalt dealer for repairs.
• If debris is seen within the container, close the
appropriate seacock and remove the strainer
cover. Lift strainer from container and
thoroughly clean. If the container is full of
sediment, remove the plug at the bottom of the
container and allow water to drain into the
bilge. Remove the container and clean any
sediment. Install the container and plug. Install
strainer in container and secure cover. Open
the seacock and check for leaks.
5. Start engine(s) and the generator (if equipped).
Check all exhaust systems for leaks. If you
notice a leak, see your authorized Cobalt
dealer.
6. Check all fuel lines and connections at fuel
tanks, engines and the generator for leaks. If
you detect a fuel leak, immediately see your
authorized Cobalt dealer.
7. Check the portable and automatic fire
extinguishers for proper charge.
8. Check the battery charge of both engine
batteries. Be sure that the batteries can start
the engine(s) and the generator, if equipped,
before proceeding on your cruise.
Every 50 Hours
1. Be sure to clean seawater strainers as
described in Before Each Use , Step 3.
Every 50
Hours Clean seawater strainers if
equipped.
Inspect propellers for damage.
Every 100
Hours Test for proper operation of the
ignition safety switch.
Clean bilge area.
Monthly Test GFCI outlets, if equipped.
Check self-sacrificing anodes.
Quarterly Have your authorized Cobalt
dealer perform scheduled
maintenance as outlined in this
section.
CAUTION
• Seacocks can only be replaced when
the boat is out of the water.
• Make sure a seacock is in the CLOSED
position before replacing a hose.
Frequency Task
CAUTION
Seacock must be in the CLOSED
position before servicing a strainer.
A
DANGER
Avoid the risk of fire or explosion. DO
NOT operate your boat if a fuel leak is
detected. All fuels are combustible. A
fuel leak must be repaired before
starting the engine(s) or the generator (if
equipped).