Cobalt Digital Inc 9980-CSC-3G, Руководство по эксплуатации продукта, Страница: 48 / 76

3
9980-CSC-3G Function Menu List and Descriptions
3-20
9980-CSC-3G PRODUCT MANUAL 9980CSC3G-OM (V1.4)
Ancillary Data Proc Controls
Provides controls for VANC/HANC ancillary data
de-embedding and embedding to and from program
video stream. Data can be extracted and inserted
within the device (Bridge mode). This can be used to
move ancillary data to another line, or to remove
ancillary data.
GPO Setup Controls
Provides controls for setting up the two GPO’s
power-up states as well as forced manual or event
action triggered.
Note:
This tab has identical independent controls for GPO 1 and 2. Therefore, only the GPO 1 controls are described here.
• Current State indicates GPO status regardless of any pre-setup.
• Power-on State allows the power-up GPO state to be set
(initialized) upon power-up
• Control Mode allows GPO manual asserted open or closed states,
or hands over control to Event Action triggering.
Table 3-2 9980-CSC-3G Function Menu List — continued
•
•
•
Eight individual Ancillary Data Processors (ADPs) provide for bridging ancillary data to and from the program video SDI stream.
Bridge extracts ANC from the deserialized
input video and re-inserts in the output
video, thereby allowing specialized ANC
packets to be retained and moved to another
VANC/HANC location
DID and SDID controls select the
desired packet to be handled by the
corresponding ANC Data Processor
Line Number controls select the
VANC location of packet insertion/
extraction.
Setting the line numbers to 0 (zero)
lets externally-sourced payload
assert and set the line number. Insertion controls allow
special insertions in HANC
or the C-channel, as well as
removal of incoming packets
In the example above, ADP Proc 1 is set to extract ATC timecode at DID60
h
/ SDID 60
h
. Depending on the interface used to carry the extraction (COM or
IP), status is displayed as shown below.
Note: DashBoard versions 4.1 and earlier display DID and SDID numbers in decimal; newer DashBoard versions display DID and SDID numbers in
hexadecimal. Hexadecimal notation is denoted by the “0x” preceding the value.
When set to extract to COM interface, displays rate and dropped data (if any)
When set to extract to IP interface, displays rate and total amount transferred