Cobalt_OM_preprint_shell.fm Page 1 Wednesday, March 1, 2006 5:39 AM
336 Owner’s Manual
3-23
O
PERATING
I
NFORMATION
1. GAUGE CLUSTER
General Gauge Operation
System Architecture
Each gauge system consists of two Data Interface
Gauges and several auxiliary/slave gauges. The
Data Interface Gauge collects information from the
CAN bus and analog inputs, and drives the
auxiliary gauges via a low-speed data bus. The
auxiliary gauges receive power from the Data
Interface Gauge. The backlight of all the gauges is
powered on a connector terminal, not associated
with any data bus.
System Start-up
At key on, all the gauges will perform a pointer
reset (goes to zero or minimum reading). The Data
Interface Gauge speedometer and the tachometer
will perform an LCD all-segments-on test. Once
these initializations are complete, the gauges will
begin non start-up operation.
System Shutdown
At key off, all gauge pointers will return to “zero” or
minimum value. The Data Interface Gauges will
turn their LCDs off and shut power off to the
auxiliary gauge.
Speedometer LCD Operation
The speedometer will display the following
information in the LCD:
Water Depth
- Digital readout of water depth (ft or
M).
Air Temperature
- Outside air temperature
(in degrees F/C).
Lake Temperature
- Temperature of lake water
(in degrees F/C).
Tachometers LCD Operation
Both gauges have buttons on the bottom of the
gauges to scroll through the information available in
the LCD. The right button will advance the screens
forward and the left button back.
Available Information in Port Tachometer
Hour Meter
- Run time calculated by the engine’s
computer.
Tachometer
- Digital readout of engine RPM.
Oil Pressure
- Digital readout of engine oil
pressure (PSI or KPA).
Engine Temperature
- Digital readout of the
engine temperature (in degrees F/C).
Block Pressure
- Digital readout of the water
pressure inside the block (not available on Volvo
engines).
Battery Voltage
- Digital readout of battery voltage.
Trim Angle - N/A w/EVC
- Digital readout of the
drive angle with zero degrees being straight down.
Available Information in STBD Tachometer
Hour Meter
- Run time calculated by the engine’s
computer.
Tachometer
- Digital readout of engine RPM.
Miles Per Hour
- Digital readout of the vessel’s
speed through the water (Merc. only) (MPH or
KMH).
Oil Pressure
- Digital readout of engine oil
pressure (PSI or KPA).
Engine Temperature
- Digital readout of the
engine temperature (in degrees F/C).
Block Pressure
- Digital readout of the water
pressure inside the block (not available on Volvo
engines).
Battery Voltage
- Digital readout of battery voltage.
Fuel Level/Fuel Burn Rate
- Amount of fuel in fuel
tank in percentage and the rate the fuel is being
burned (in GPH or LPH).
Trim Angle - N/A w/EVC
- Digital readout of the
drive angle with zero degrees being straight down.
Rudder Angle - Optional and N/A w/EVC
- Slide
bar showing the position of the drive (when option
is purchased/Merc only).
Water Depth
- Digital readout of water depth (ft or
M).
Air Temperature
- Outside air temperature
(in degrees F/C).
Содержание 336
