Cobalt_OM_preprint_shell.fm Page 1 Wednesday, March 1, 2006 5:39 AM
296 Owner’s Manual
3
-
25
O
PERATING
I
NFORMATION
Navigational Lights - You must use your
navigational lights (running lights) when operating
your Cobalt boat between sunset and sunrise, and
when daytime visibility is limited. Also, check with
the local authorities before operating your boat for
other requirements concerning the use of
navigational lights.
The navigational lights are identified by a red light
on the port side of the vessel, and a green light on
the starboard side.
Anchor/Mooring Light - All boats at anchor or
moored must display a proper white anchor light.
The anchor light (all-around light) is the white light
located aft of the cockpit. The anchor light must be
visible from 360° and will remain on when operating
the navigational lights.
ENGINE HATCH -
This switch operates the electric
(twin engine) or hydraulic (single engine) motor box
assembly. Do not continue to operate the switch
when the motor box is closed or fully open. Lower
the motor box support after the motor box is
opened. Be sure to return the support to its stowed
position before lowering the box.
DIMMER -
This switch controls the brightness of
the helm instrument lighting.
ACC. HEATER (Optional) -
This switch operates
the optional cockpit heater blower. It is a
four-position switch: OFF/LOW/MEDIUM/HIGH.
Temperature can be controlled by the switch and by
adjusting the louvered vents. The cockpit heater will
only be effective (warm enough) when the engine is
running at normal operating temperature.
ACC -
This switch is available to operate switched
accessory items.
7. IGNITION SAFETY SWITCH
Your Cobalt boat is equipped with an ignition safety
switch located on the lower lip of the helm. The
ignition safety switch and lanyard will stop the
engine in case of an emergency. Attach the lanyard
to the boat operator whenever the engine is
running, but be aware there will be a loss of boat
control if the switch is activated. If the operator is
thrown from the seat or moves too far from the
helm, the lanyard will become disconnected from
the ignition safety switch, shutting off the engine.
1 – Ignition Safety Switch
2 – Lanyard
3 – Hook
NOTICE: DO NOT connect an
accessory drawing more than 10
amps to the accessory switch. A
hazardous situation or damage
to the electrical system can
occur.
A
WARNING
Avoid injury, death or damage to
equipment. Do not allow your boat to be
operated without the proper use of the
ignition safety switch and lanyard.
COB_0042_A
2
1
3
Содержание 296 BOWRIDER
