Coachmen RV Viking, Руководство пользователя

Страница: 17 / 32

17
12V / 110 / GAS REFRIGERATOR
The gas and electric controls are located in the rear of the
refrigerator and are accessible through the doors in the outside wall
of the vehicle. To remove the doors, turn the black buttons on the
lower corners 90° counter-clockwise to release.
Refer to manufacturer’s operation manual supplied with
appliance.
NOTE:
Keep items to be stored in your RV refrigerator or ice
box in your home refrigerator or freezer until you are ready to leave.
This will reduce the cooling load on your RV refrigerator or ice box
and help keep perishable foods fresh longer. Always store food in
sealed containers or suitable wrapping. During travel, use the door
latch.
• The refrigerator requires 24 hours running time to cool
down.
• If the refrigerator has been out of use for an extended
period, make sure all air vents are free from obstruction
and check for gas leaks using soapy water.
• Never cover or partially cover the air vents with cardboard
or anything else.
• Remember to level the vehicle when stopping for more
than about an hour, otherwise the cooling unit could be
permanently damaged due to overheating if it is left on.
For recommended maintenance, refer to appliance instruction
booklet.

!
WARNING!
Turn on only one energy source at a time.
FURNACE
– See manufacturer’s owner’s manual
The RV furnace is an LP gas appliance. Heat is discharged into
the unit directly through the furnace grill. To operate the furnace,
first remove cabinet front. Turn main gas valve control knob to the
OFF position. Move OFF lever, located at the bottom of thermostat
to the right if set on OFF position. Set the thermostat above room
temperature. A slight delay will occur before the blower starts. Allow
the blower to run for five minutes for combustion chamber purge
cycle. After five minutes, set thermostat below room temperature.
Turn main gas valve control knob to ON position. Set thermostat
above room temperature. Allow 30 seconds for ignition to occur
after the blower comes on. If burner does not ignite, return main
gas valve control knob to OFF. Set thermostat on OFF.
NOTE:
If after three attempts with no ignition, go to shut-down
and contact a qualified service agency. Do not continue to cycle
furnace through thermostat in an attempt to get ignition.
CARE OF FURNACE
Your furnace should be inspected before use at least annually
by a qualified service agency. Particular attention should be given
to the combustion chamber gaskets, soot in vent and main burner.
Check your furnace owner’s manual (supplied with furnace) for
more information and before operation of furnace.

!
WARNING!
DO NOT use catalytic or open flame heaters in
your Viking unit. This includes wood and charcoal
grills and stoves. The use of this equipment inside
the vehicle may cause fires. These devices, either
portable or permanently installed, consume oxygen
from the interior space and may contaminate the air
with toxic fumes. These fumes may cause nausea,
dizziness or death.
WATER HEATER (Limited Application)
– See manufacturer’s owner’s manual
The water heater is an LP gas appliance capable of heating
water to a preset temperature. The water heater features an electric
ignition. When the system is connected to city water, fill the water
heater by opening a hot water faucet. When filling the fresh water
tank, turn the water pump ON and open a hot water faucet. In either
case, when water flows steadily, turn the faucet OFF. Any air still in
the tank can be removed by opening the relief valve in the outside
access compartment.

!
WARNING!
Do not turn on water heater switch until heater tank
is full. Damage will occur to water heater if turned on
when empty!
See manufacturer’s directions for use
and care of water heater.
MAINTENANCE
GENERAL
Recreational vehicle owners are noted for the pride they take
in the appearance of their units. Proper maintenance will do more
than keep your Viking unit looking nice. It can help insure trouble-
free operation and maximum efficiency of the various appliances
and components. Failure to properly maintain the vehicle or
its components also may constitute a breach in your warranty
obligations. Negligence, misuse or installation of unauthorized
equipment could affect the operation of your unit and may void
your warranty. See the various manufacturer’s manuals for specific
maintenance instructions.