12
ENGL
IS
H
Changing the units of temperature, °C or °F
Remote control
Hold in [
▲
TEMP
▼
] to switch between units.
Main unit
Hold in [ + ] and [ − ] simultaneously to switch between units.
The Cool, Dry and Fan Modes
• The Cool, Dry and Fan modes can be controlled both from the main unit and using the remote control. The instructions
below explain how the modes are controlled from the main unit. In some of the modes, the fan speed can only be set
using the remote control (see below).
• If you wish to use the remote control: Press [ MODE ] on the remote control and set the temperature with [
▲
TEMP
▼
].
Air Conditioner Mode (Cool)
1. Plug the mains lead into a wall socket.
2. Switch the air conditioner on.
3. Press [ MODE ] until the “Cool” indicator lights up.
4. Press [ + ]/[ - ] to set the desired temperature, 17–30 °C (62–86 °F). The display shows the set temperature.
Note:
The fan speed cannot be set using the control panel on the main unit. Set the desired fan speed using the remote control.
Dehumidifier Mode (Dry)
Note:
The dehumidifier mode can be operated in two ways. With or without the drain hose connected. If the drain hose is
not connected, the built-in water tank of the air conditioner will fill relatively quickly (depending on ambient humidity) and will
need to be emptied manually. The most efficient way of dehumidifying is therefore to utilise the continuous dehumidification
method (see below).
Continuous dehumidification (recommended)
1. Plug the mains lead into a wall socket.
2. Switch the air conditioner on.
3. Unscrew the cover over the drain hole (4), remove the rubber plug and connect
the included drain hose (11).
4. Position the drain hose so that the water will drain away adequately.
5. Press [ MODE ] until the “Dry” indicator lights up.
Note:
The temperature and speed
cannot be set when the dehumidifier mode (Dry) is activated. The display shows
the present room temperature.
Dehumidification without the drain hose connected
1. Plug the mains lead into a wall socket.
2. Switch the air conditioner on.
3. Press [ MODE ] until the “Dry” indicator lights up.
Note:
The temperature and speed
cannot be set when the dehumidifier mode is activated. The display shows the present
room temperature.
4. Dehumidification takes place until the built-in water tank is full. When the tank is full,
the error code “P1” appears on the display and the air conditioner will beep 8 times.
5. Move the air conditioner to a suitable drain, unscrew the cover of the lower drain port (8),
pull the rubber plug out of the hole and let the water drain out.
6. Reinsert the rubber plug and screw the cover back on.