6.3in
160mm
X Axis
X' Axis
6
1
3
4
2
5
Front
Back
Eccentric
Concentric
6.3in
160mm
Spacing Detail
Step 2: X-axis Crossmembers
Parts Added
A) Use the anchor fasteners to attach the crossmembers to the
bottom T-slot of the X-axes. Install the front crossmember flush
with the end of the axis extrusion first, then install the next two
spaced 160mm[6.299in] apart to facilitate the installation of the
T-slot table extrusion. A piece of table extrusion can be used to
verify this spacing. (See Step 9).
8020 Inc. has videos on how to use the anchor fastener.
One video can be found at youtu.be/watch?v=y13-J3wtwCQ
Other instructions can be found by searching "8020 anchor
fastener"
B) Install the V-Con wipers on the concentric bushings on the
top the two axes. The axes are labeled and should be oriented
as shown. If oriented improperly, the eccentric bushings will be
on top instead. The V-Con wipers cannot be installed on the
eccentric bushing. (See below.)
✔
✖
Fasteners in bag: CRP613-00-FAST
Fasteners in bag: CRP610-00-FAST
#
PART
QTY
1
CRP610 Ballscrew X-Axis
2
2
BHCP-M8-30, M8 Button Head Cap Screw x 30mm
12
3
TNR-M8, Roll in M8 T-nut
12
4
2002, Anchor Fastener
12
5
4080 Extrusion x 641 mm
3
6
V-Con Wiper
4
Updated 10/26/2015
SHEET 3 of 14
