CMT 8E, Инструкция по эксплуатации и безопасности

Страница: 12 / 76

12 Table Mounted Operation/Maintenance
3. Re m ove the router
and drill a pilot hole
through the centre
of your circle. Using
a 12
mm (1/2 ” ) bit drill
your final access hole.
File off any rough
burrs using a
round file.
4. Refit the router and
turn the router
table right way up.
5. Fit the table winder
handle (17) through the hole in the
tabletop and push it onto the routers
winder
m echanis m .
If necessary extend your hole using a
round file.
6. Release the plunge lock lever and use the
winder handle to set your cut depth.
Calibration m arks :
Each line on the winder
wheel represents 0.2
mm
(1/128 ” ) cut depth
incre m ents. A full 360
degree turn is equal to
a 2
mm (3/32 ” ) depth
adjust m ent.
7. Re-lock the plunge lock lever and
co mm ence your work.
s !NYDAMAGETOTHEROUTERSHOULDBE
repaired and carefully inspected before
use, by qualified repair personnel. Service
or
m aintenance perfor m ed by unqualified
personnel could result in a risk of injury.
s 3ERVICINGSHOULDONLYBECARRIEDOUT
by authorised CMT Repair Centres
using original CMT replace
m ent parts.
Follow instructions carefully and refer
to
“ Trouble-shooting ” for proble m
identification and advice. Use of
unauthorised or faulty parts
m ay create a
risk of electric shock or injury.
s #-4-ANUFACTURING$ESIGN#OWILLNOT
be responsible for any da m age or injury
caused by unauthorised repair of the
router or by
m ishandling of the tool.
BRUSH REPLACEMENT
The carbon brushes are a consu m able ite m
which should be inspected periodically and
replaced when worn. Failure to do so
m ay
result in da m age to the m otor.
1. With the router disconnected fro m power,
unscrew the Brush Caps located on the
front and rear of the
m otor.
2. Re m ove the brushes by pulling carefully on
the protruding springs.
3. If either of the
brushes is worn
to less than 6
mm
long, they m ust
both be replaced
using genuine CMT
replace
m ent brushes
- available fro m
Authorised CMT Repair Centres.
POWER CORD REPLACEMENT
If the supply cord needs replacing, the
task
m ust be carried out by the
m anufacturer, the m anufacturer’s agent,
or an authorised service centre in order
to avoid a safety hazard.
MAINTENANCE
GB