AN241
www.hoperf.com
Copyright © By HOPERF
V0.4 | Page 20/41
CM T2 31 0A EB GU I
12 DC D C Se l ec t
O ff
1. Rolling option area
Figure 2-16. DC DC Select Submenu interface
No.
Function
Description
1
Rolling option area
The options can be switched by short pressing K3 or K4
：
Off
，
disable the embedded DC DC module software configuration
；
On
，
enable the embedded DC DC module software configuration
；
After selecting the corresponding modulation and demodulation mode,
selection can be confirmed by short pressing K2 or K5, and return to the
upper menu (that is, the main menu).
Note: As mentioned above, the software configuration of DC-DC should be consistent with the hardware of
CMT2310A-EM. That is, if the DC-DC software configuration is enabled, the jumper selection of EM module
should also be enabled. If the software the software configuration is disable, the EM module jumper will be
turned off.
2.15 Gaussian Select Submenu
Select
13 Gaussian Select
and press K5 to enter the submenu, as shown in figure 2-17.
CM T2 31 0A EB GU I
13 G aus si an Se l ec t
O ff
1. Rolling option area
Figure 2-17. Gaussian Select submenu interface
