AN103
Rev 1.0 | Page 15 / 23
www.cmostek.com
7. RFPDK
RFPDK (RF Products Development Kit) is a member of the CMT2110A/2210A One-Way RF Link Development
Kits supporting the development and manufacturing with CMOSTEK NextGenRF
TM
products. It is a PC
application runs on Windows 2000, XP, 7 and 8. It works with the USB Programmer to configure the CMOSTEK
NextGenRF
TM
products.
7.1 Installation Steps
Important Note
: Before installing this software, local administration rights must be obtained from your network
administrator.
Double click the RFPDK setup icon in the CDROM to install the RFPDK onto the computer.
Figure 10. RFPDK Setup Icon
7.2 Starting the RFPDK
The RFPDK can be started by double-clicking the RFPDK icon on the PC Desktop, as shown in Figure 11 below.
For Windows 2000, XP and 7, the user can also start the RFPDK from the Microsoft Windows
®
Start button by
clicking Start
All Programs
CMOSTEK
RFPDK
CMOSTEK RFPDK V1.01.
Figure 11. Starting RFPDK from PC Desktop
Once the program has started, the device selection panel of the RFPDK appears as shown in Figure 12. The user
can use the two tabs at the top of the panel to choose the product family: either devices operating in the 2.4 GHz
frequency band or the sub-1 GHz frequency band. Under each tab, all the products belong to the family are listed
in the middle of the panel. The products can be filtered by the buttons of All, Transmitters, Receivers and
Transceivers. The main features of the products, including Device, Function, Band, Package, Modem and
Symbol Rate, are shown to assist the device selection.
If an evaluation module is connected to the PC through the USB Programmer, the device part number, USB
Programmer hardware version and firmware revision will appear in the “List of connected device”.
The rest part of this chapter takes configuring the CMT2110-EM with the RFPDK as an example unless otherwise
noted.
