2
Specifications subject to change without notice. 32802000102
A NOTE ABOUT SAFETY
Any time you see this symbol
in manuals, instructions and on the
unit, be aware of the potential for personal injury. There are three
levels of precaution:
DANGER
identifies the most serious hazards which will result in
severe personal injury or death.
WARNING
signifies hazards that could result in personal injury or
death.
CAUTION
is used to identify unsafe practices which could result in
minor personal injury or product and property damage.
NOTE is used to highlight suggestions which will result in enhanced
installation, reliability, or operation.
GENERAL
The high wall fan coil unit provides quiet, maximum comfort. In
addition to cooling and/or heating, the high wall fan coil unit
matched with an outdoor condensing unit filters and dehumidifies
the air in the room to provide maximum comfort.
IMPORTANT:
The high wall fan coil unit should be installed by
authorized personnel only; using approved tubing and accessories. If
technical assistance, service or repair is needed, contact the installer.
The high wall fan coil unit can be set up and operated from the
remote control (provided).
If the remote is misplaced, the system
can be operated from the “Auto” setting on the unit.
Operating Modes:
The high wall fan coil unit has five operating modes:
• FAN Only
• AUTO
• HEATING (heat pump models only)
• COOLING
• DEHUMIDIFICATION (DRY)
Fan Only
In the
FAN Only
mode, the system filters and circulates the room air
without changing room air temperature.
Auto
In the
AUTO
mode, the system automatically cools or heats the
room according to the user-selected set point. mode, the system
automatically cools or heats the room according to the user-selected
set point.
NOTE: Auto mode is recommended for use on Single Zone
applications only. Using Auto changeover on multi-zone
applications could set an indoor unit to STANDBY mode,
indicated with two dashes (--) on the display, which will turn off
the indoor unit until all the indoor units are in the same mode
(Cooling or Heating). Heating is the system's priority mode.
Simultaneous Heating and Cooling is not allowed.
Heating
In the
HEATING
mode, the system heats and filters the room air.
Cooling
In the
COOLING
mode, the system cools, dries and filters the room air.
Dehumidification (DRY)
In the
DEHUMIDIFICATION
mode, the system dries, filters and
slightly cools the room air temperature. This mode prioritizes air
dehumidification but it does not take the place of a dehumidifier.
Wireless Remote Control
The remote control transmits commands to set up and operate the
system. The control has a window display panel that displays the
current system status. The control can be secured to a surface when
used with the mounting bracket provided.
Wired Remote Control (Optional)
Refer to the Wired Controller manual.
24V Interface (Optional)
Allows the control of the Ductless System with a third party thermostat.
PERSONAL INJURY, DEATH AND / OR PROPERTY
DAMAGE HAZARD
Failure to follow this warning could result in personal injury,
death or property damage.
Improper installation, adjustment, alteration, service,
maintenance, or use can cause explosion, fire, electrical
shock, or other conditions which may cause personal injury or
property damage. Consult a qualified installer, service
agency, or your distributor or branch for information or
assistance. The qualified installer or service agency must use
factory-authorized kits or accessories when modifying this
product.
Read and follow all instructions and warnings, including
labels shipped with or attached to unit before operating your
new air conditioner.
WARNING