CMF Power Select, Инструкция по установке и эксплуатации, Страница: 6 / 40

Installation / Operation Instructions
CMF Power Select Ver. 3.0
REV 6.3
5
2.3.10 Mount the operator panel in the desired location. Connect the communication
wire between the operator panel and the main panel (located on the Power
Select). Shielded CAT5e cable is recommended for this connection. See dwg
502950-E for details. Observe all applicable codes for control installations.
2.3.11 Connect the power supply wires to the terminals provided in the main panel and
in the operator panel. See electrical schematics for details.
2.3.12 Turn on power to the main panel, and the operator panel.
2.3.13 In order to make the adjustments needed for the system to function properly, it
will be necessary to manually operate the unit. Manually moving (jogging) the
Power Select is accomplished by starting the hydraulic pump and then pushing or
pulling the red manual override disks located on the ends of the solenoid valves.
(Fig 1)
Note: You will notice that it is much easier to push the valves than to pull
them. This is normal.
Fig. 1: Solenoid Valve Override