TECHNIC
AL D
AT
A SHEE
T
DISHWASHER EST- 44
4
STEP
11
Switch Manual/Auto switch to Manual Mode.
Adjust Pressure Regulator Valve to 20 PSI.
If E-Temp is installed on machine, press rinse
switch to fill E-Temp tank.
Return Manual/Auto
switch to Auto Mode.
PRESSURE REGULATOR
LOCATED BEHIND
CONTROL BOX
ON-OFF
ON-OFF
Adjust thermostat if necessary. Water temperature
should be 140F rinse and 140F wash for EST44L.
The EST44H should read 180F rinse 155F wash.
EST44 FRONT VIEW
11-2016
Turn on dishmachine by pressing the "POWER
ON/OFF"switch to the "ON"position. Dishmachine
will fill automatically and will also activate heater.
Close drain valve before filling machine with water.
9
STEP
C LOS
E
Remove the stainless steel plug to install the detergent
probe (provided by dispenser manufacturer, CMA does
not supply).
7
STEP
Remove motor cap to verify motor rotation. Shaft slot
should be rotating clock-wise when motor is running. If
shaft slot is turning counter clock wise, swap L-1 and L-3
on main contactor.
EST-44/66
Quick Setup
Instructions
WARNING
: Electrical and plumbing
connections need to be made by a
licensed service person and comply
with all Federal, State and Local
Health, Electrical, Plumbing and
Safety codes.
10
STEP
6
STEP
8
STEP
RINSE
WASH
*PRESSURE REGULATOR LOCATED
BEHIND CONTROL BOX
AUTO/MANUAL
SWITCH
AUTO/MANUAL
SWITCH
RINSE TEMP
WASH TEMP
RINSE TEMP
WASH TEMP
ON-OFF
AUTO/MANUAL
SWITCH
RINSE TEMP
WASH TEMP
GAUGE
POWER
ON/OFF
10
DETERGENT
PROBE INLET
STAINLESS STEEL
SCRAP TRAP
TEMPERATURE
GAUGES
WASH
THERMOSTAT
MANUAL AUTO
SWITCH
11
11
e
-TEMP
6
8
RINSE PRESSURE
11
* PRESSURE
REGULATOR
PRESSURE
GAUGE
11
RINSE
THERMOSTAT
8
MOTOR CAP
7
DOOR SAFETY SWITCH
DRAIN VALVES
9
The Spirit of Excellence
an Ali Group Company
