TECHNIC
AL D
AT
A SHEE
T
DISHWASHER EST- 44
3
HOT WATER
SUPPLY LINE
1/2" INLET
EST44
REAR VIEW
11-2016
EST-44/66
Quick Setup
Instructions
Connect Hot Water Supply Line to 1/2"Final Rinse
Water Inlet. SEE STEP 11.
Connect Fill Water Supply Line (120F/140F) to a 1/2"water
inlet to fill the machine.
Connect drain at either end of the horizontal
drain pipe from wash tank or scrap trap drain.
3 Phase: Connect the wire with the highest voltage
(stinger lead) to L2 on the contactor. L1, L2 and L3
must comply with all local and state electrical codes
for sizing of wire and circuit breaker protection.
Additional information can be found in the
Installation and Operation manual supplied with
machine.
Remove plug to install detergent fitting. Remove plugs from
the mixing chamber to install sani/rinse injection fitting
(sanitizer, detergent and rinse injection fittings provided by
dispenser manufacturer, CMA does not supply.)
WARNING
: Electrical and plumbing
connections need to be made by a
licensed service person and comply
with all Federal, State and Local
Health, Electrical, Plumbing and
Safety codes.
1
STEP
4
STEP
2" HOLE
PLUG
3
STEP
VOLTS
PHASE
AMPS
208
1
76
240
1
84
208
3
50
240
3
54
HEATER 10kW
5
STEP
REMOVE
PLUG AND
INSTALL
DETERGENT
FITTING
PLUGS
ELECTRICAL
CONNECTION
3
2
1/2" FILL
WATER INLET
1/2" FINAL RINSE
WATER INLET
1
DETERGENT
FITTING INLET
5
MIXING
CHAMBER
5
SCRAP
TRAP DRAIN
4
DRAIN PLUMBING
NOT SUPPLIED
OPTIONAL VENT
HOODS 4"X16"
2" HOLE
PLUG
DRAIN PIPE
4
2
STEP
FILL WATER
SUPPLY LINE
FILL WATER
SUPPLY LINE
1/2" INLET
ELECTRICAL
HARD WIRE
CONNECTION
POINT
PN: 10130.21
