CMA Dishmachines EST-FL, Руководство по установке и эксплуатации

Страница: 5 / 14

Getting Started
MODEL EST Front Loader INSTALLATION & OPERATION MANUAL Rev. Draft
Page 4
2.2. Receiving and Installation
The dishmachine is shipped from the factory in a corrugated box on a wooden pallet.
The installation guidelines give a systematic procedure for setting up the machine.
Start by removing the dishmachine from the box, and remove all the packaging materials.
Unwrap the machine, and check for the following components:

Inside the wash tank is a plastic bag with one control box key and a cam timer
wrench.

Tube stiffeners must be used to prevent the feed tubes from curling inside the
chemical pail and sucking air. These are located on the outside of the machine with
the chemical tubing already installed into the stiffeners. The ends of the chemical
tubing have been flared so that the tubing will not pull out of the stiffener. Red is for
detergent, white for sanitizer, and blue for rinse aid.
2.2.1. Electrical
*
Prior to installation make sure the electrical supply is compatible with the specifications on the
machines data plate.
The EST-FL Dishmachine must be hard wired directly to a dedicated 115 VAC, 60Hz circuit
equipped with proper circuit protection. The main power switch is at the top-right side of the
control box.
WARNING: Electrical and grounding connections must comply with the applicable portions of the
National Electrical Code and/or other local electrical codes.
Note: For supply connections, use copper wire only rated at 90 degree C minimum.
2.2.2. Plumbing
*
The water supply connection is made with a ½” hot water line to the water supply inlet on the top
of the dishmachine. The water supplied to the machine is recommended to be 140° F. The time
necessary to deliver water to the machine is controlled by the number four cam.
The EST-FL Front Loader Dishmachine has a 2” drain. The following section explains how to
connect the drain.
*
Electrical and plumbing connections must be made by a qualified person who will comply with all
available Federal, State, and Local Health, Electrical, Plumbing and Safety codes