CMA Dishmachines EST-44, Руководство по обслуживанию и запасным частям

Страница: 11 / 55

Getting Started
MODEL EST-44 Service and Parts Manual Rev. 2 .08A
Page
9
2.2.4. Scrap Tray Assembly Installation
The Scrap Tray Assembly and Overflow Chute, which were shipped inside the machine, can
easily be installed by executing the following steps:
Figure 2.2.4 below illustrates the assembly,
as it would appear for a Left-to-Right machine
– (a Right-to-Left machine would simply be the
mirror image).
Caution:
1. For proper spacing, the SS flat washer must not be located between the head of the truss
head bolt and the inside of the machine.
2. The Illustration below shows the correct placements of the scrap trap holder. Do not
install upside down, otherwise water deflection takes place.
Figure 2.2.4
1.
Remove items from their packaging and verify that all “installation hardware” was included.
2. Secure the scrap trap holder to the dishmachine by using the four ¼-
20 X ½” Hex Head
Bolts, the ¼” SS Flat Washers, and the ¼”-20 Nylon Lock Nuts that were provided.
3. Set the scrap trap body
—with the scrap trap drawer inserted—into position on the scrap trap
holder. (Attach the drain as specified in Section 2.2.3)