MODEL CMA-180VL Service & Parts Manual Rev. 2.01
Page
9
flexibility to permit the machine to be moved for cleaning without having to
disconnect any wiring.
ii.
Run your dispenser wires through the conduit to the control box.
iii.
Run your probe wires to the control box.
iv.
With the machine’s power “OFF”, connect your detergent and rinse dispenser
wires to the red and blue terminals of the power block supplied inside the control
box. The table that follows lists the function of each conductor of the multi-
conductor electrical cable.
Wire Colors
Circuit Voltage
Function
Gray/Violet
200 VAC-249 VAC 50/60 Hz
Main AC Power
Brown
200 VAC-249 VAC 50/60 Hz
Main AC Power
Black
No Connection.
Insulate this wire!
This wire is LIVE!
Yellow
24 VAC-240 VAC 50/60 Hz
Detergent Signal
White/Yellow
24 VAC-240 VAC 50/60 Hz
Detergent Signal
Violet
24 VAC-240 VAC 50/60 Hz
Rinse Signal
White/Violet
24 VAC-240 VAC 50/60 Hz
Rinse Signal
The individual conductors need to be connected as shown on the wire
diagram below. Probe wires are to be striped, crimped on barrel male and
female connectors provided, and connected to the pre-wired violet wires in
the control box.
2. Remove the plug from the mixing chamber located by the vacuum breaker on the
back of machine; and install the rinse injection fitting (supplied with your
dispenser).
3. A 7/8” detergent injection hole is provided in the back of the wash tank. Remove
the S.S. plug and install the detergent fitting (supplied with your dispenser).
